Posts Tagged ‘carpet sprouts’

Inspection Safari: Carpet Sprouts – Causes and Solutions

Thursday, August 28th, 2014

carpet yarn sprout | carpet expert Glenn Revere

Last week, I inspected a large commercial installation. The complaint came in as “loose tufts and snags”. What I found was something very different: sprouts.

As defined in my book, All About Carpets, “sprouts are long ends of yarns that protrude above the pile surface…Sprouting is a defect only if excessive and unserviceable.”

When I looked across the large, open, glued-down (no padding) installation, it appeared someone had dropped small ball bearings all over this tufted carpet. What I actually saw were random longer loops of carpet pile that were sticking up above the rest of the level loop pile. So what was going on? Had something yanked loops out of the carpet backing? Or was it something else?

Tufted carpet is made by using needles that stitch carpet yarns into a thin sheet of material. As many as 1,000 needles run across a width of carpet. Each needle sets a looped yarn at a predetermined height. For cut-pile carpet, a knife cuts (more…)

Carpet Problems: Carpet Sprouts and Snags

Thursday, March 6th, 2014

carpet yarn sprout | carpet expert Glenn Revere

Carpet sprouts and snags are tufts that have worked themselves up so that they are higher than the surrounding pile.

Snags are face yarns, cut or loop, that have been pulled from the backing by something in the home. Snags are more common with loop piles. Vacuum cleaners with sharp corners or broken parts, pets, protruding nails from shoe heels, chair legs, and children can all pull out tufts and cause snags. Single snags should be clipped flush with (more…)