Posts Tagged ‘carpet installation tips’

Carpet Installation Tip: Always Hire Certified Flooring Installers

Thursday, September 4th, 2014

Like any other craft, carpet installers’ skills vary widely. Installers learn their craft by starting as apprentices with a crew. An apprentice might only take up the old carpet and carry tools at first, but slowly learns by watching the others perform their jobs. In this way, the apprentice learns to become an installer.

But hold on! What if the apprentice learns bad installation techniques?

The apprentice doesn’t know any difference between bad and good installations. I have seen apprentices learn from installers who have been doing things the wrong way for thirty years. How do you know that the crew who shows up to install your carpet (after you worked so hard to haul out the furniture!) knows what they’re doing? How do you know that the head of your installation crew wasn’t yesterday’s apprentice? (Note: A lot of retailers hire the lowest bidder and don’t even bother to check the finished job — until there’s a complaint!)

The answer is: always hire a (more…)

How to Seam Carpet and Why Carpet Seaming is Important

Tuesday, April 22nd, 2014

carpet seam sealing | Glenn Revere

Installing carpet correctly is not an easy job. There is more to it than “fuzzy side up”! An installer can spend years learning about the finer points of his (or her) craft. One key point that is frequently skipped completely is carpet seaming. “What is that?” you might ask.

Carpet is a fabric that is cut off a long roll and then cut again as needed to fit a room or rooms. Unless the rooms are slightly smaller than width of the carpet, the pieces must be seamed (joined) together into larger pieces to fit the rooms to be carpeted. (more…)

Carpet Problems: All About Carpet Buckling and Wrinkling

Tuesday, April 15th, 2014

Carpet buckling occurs when a carpet loses its stretch and wrinkles develop. It can happen because of poor latexing, improper stretching, a soft pad, excess humidity, improper cleaning, or rolling furniture or equipment. Puckers around doorways and wrinkles in the traffic areas are sure signs of buckling.

Poor Latexing

Just as poor latexing leads to weak tuft bind, it can cause a carpet to lose its stretch. Brittle, powdery, or thin latex will make a carpet too flexible and make it impossible to lay tight. If the latex application is not strong enough to bind the primary and secondary backings together, the carpet delaminates. Air gets trapped between the two layers and you’ll see bubbles and buckles. When this happens along a seam, the seam opens up. You can stick your fingers between the two backings. When it happens in the center of the room, the carpet will bunch up when you vacuum. You can easily lift the carpet several inches from the floor. (more…)